PP Rainwater Module 50T(Green)
PP plastic modules are injection-molded from polypropylene. By enveloping the structure with a composite geotechnical membrane, the system can function as either a storage reservoir.
PP Rainwater Module 50T(Green)
Model Number:XH-MK1000
Dimension:L*W*H=1000*500*500(mm)
Weight:9.2kg-10kg(1000*500*250 The weight of a single piece is
4.6kg-5.0kg)
The aforementioned weight excludes the side panels,which weight around
1.0kg
Compressive Strength:Vertical Compressive Strength 500kN/㎡,
Lateral Compressive Strength 150kN/㎡.
Porosity:95%
Support Column Wall Thickness:Small End 4.5mm,Large End 3.0mm
(Average Wall Thickness 3.75mm)
Related products
-
Kssc-zh061k Wet Grinding Dust Collector
Contact UsIt is main applied to flammable, explosive and big spark metal dust.
The air with dust entries into dust collector through suction inlet section under the fan working status, the bigparticles will drop into water tank bottom. -
Gel sealed Mini-pleat HEPA filter（top gel seals）
Contact UsThe two-component gel is poured into the liquid seal type HEPA filter , and this is used as an installation seal.
-
Annual output of 120,000 tons of DMF, 20,000 tons of NMF project – waste liquid and waste gas incineration treatment system
Contact UsThis project plans to build a set of waste liquid and waste gas direct-fired incinerator. Including but not limited to construction drawing design, waste gas feeding system, waste liquid feeding system, combustion assistance and feeding system, incineration system, waste heat recovery system, denitration system, smoke exhaust system, auxiliary system, electronic control instrument system, etc.
-
NGB High Temperature-resistant 350℃ Separator HEPA Filter
Contact UsThe filter material is high temperature resistant ultra-fine glass fiber filter paper, and the separator is aluminum foil corrugated sheet.
Reviews
There are no reviews yet.