Regenerative thermal incinerator (RTO)

Scope of Application

1. Coating, textile, pharmaceutical, chemical organic waste gas of low concentration, big air volume;

2. Exhaust gas composition is complex, low calorific value of poisonous smell of harmful gases;

3. Waste gas composition change constantly;

4. Waste gas containing catalyst poisoning or active element of recession (like silver, lead, tin, zinc, arsenic, phosphide, etc.).

Characteristic of Regenerative thermal incinerator (RTO)

1. Significant energy saving effect, reduce the emissions of greenhouse gases at the same time;

2. Heat exchange efficiency is better;

3. Low combustion noise;

4. Improve the efficiency of purification, also extend the life of the furnace;

5. Hierarchical combustion technology, heat effect is excellent. Environmental protection effect is excellent;

6.Organic peroxide decomposition completely;

7. PLC automatic combustion control, high degree of automation, stable operation, high safety and reliability;

8. According to the waste gas, a reasonable set of heat recovery unit, in the high temperature heat conduction oil furnace and waste heat boiler combustion chamber, low temperature flue gas used to heat the exhaust gas, make full use of waste heat;

Waste gas treatment capacity:1000 -100000 Nm3/h

Shandong Heze Derui

The English name of the regenerative thermal incinerator is "Regenerative Thermal Oxidizer", so it is called "RTO" for short. The principle is to heat the organic waste gas to above 800°C to oxidize and decompose the VOC in the waste gas into carbon dioxide and water. The high-temperature gas generated by oxidation flows through a special ceramic regenerator, which heats up the ceramic body and "storages heat". This "storage" is used to preheat the organic waste gas that enters later, thereby saving fuel consumption for raising the temperature of the waste gas. The ceramic regenerator should be divided into three regional chambers, and each regenerator undergoes the procedures of heat storage-heat release-cleaning in turn, and works continuously in a cycle. Immediately after the regenerator “releases heat”, part of the treated and qualified clean exhaust gas should be introduced to clean the regenerator (to ensure that the VOC removal rate is above 95%), and the “heat storage” program can only be entered after the cleaning is completed. .

After the regenerative thermal oxidation treatment system is preheated to 700°C under the action of the burner, the waste gas bypass valve is closed, the waste gas forward valve is opened, and the waste gas fan starts to run. The waste gas is preheated to about 700°C through the regenerator first, and then Enter the oxidation chamber to fully oxidize and decompose, the temperature of the flue gas reaches about 800°C, the organic components in the exhaust gas are completely oxidized and decomposed, and the generated flue gas enters another group of regenerators, where heat exchange is performed, and finally discharged to atmosphere. The thermal oxidation device has three regenerators in total, and the three regenerators are arranged in a line, and the working status of the regenerators can be automatically and regularly switched in turn.

Flow chat

Reviews

There are no reviews yet.

Be the first to review “Regenerative thermal incinerator (RTO)”

Regenerative thermal incinerator (RTO)

Reviews

Related products

Annual output of 120,000 tons of DMF, 20,000 tons of NMF project – waste liquid and waste gas incineration treatment system

NGB High Temperature-resistant 350℃ Separator HEPA Filter

KSZ-1.5S1/S2 Welding Fume Extractor

KSDC-8604A/A1 Centralized Dust Collector